EDORAM ~ Extended Data Out RAM

by Kyle Duke.

Share
|
Homepage | Submit your article | Contact | TOS
More articles on memory processor motherboards and buses  

You are here: Categories » Computers and technology » Memory Processor Motherboards and buses

In 1995, a newer type of memory called extended data out (EDO) RAM became available for Pentium systems. EDO, a modified form of FPM memory, is sometimes referred to as Hyper Page mode. EDO was invented and patented by Micron Technology, although Micron licensed production to many other memory manufacturers.

EDO memory consists of specially manufactured chips that allow a timing overlap between successive accesses. The name extended data out refers specifically to the fact that unlike FPM, the data output drivers on the chip are not turned off when the memory controller removes the column address to begin the next cycle. This enables the next cycle to overlap the previous one, saving approximately 10ns per cycle.

The effect of EDO is that cycle times are improved by enabling the memory controller to begin a new column address instruction while it is reading data at the current address. This is almost identical to what was achieved in older systems by interleaving banks of memory, but unlike interleaving, with EDO you didn't need to install two identical banks of memory in the system at a time.

EDO RAM allows for burst mode cycling of 5-2-2-2, compared to the 5-3-3-3 of standard fast page mode memory. To do four memory transfers, then, EDO would require 11 total system cycles, compared to 14 total cycles for FPM. This is a 22% improvement in overall cycling time, but in actual testing, EDO typically increases overall system benchmark speed by about 5%. Even though the overall system improvement might seem small, the important thing about EDO was that it used the same basic DRAM chip design as FPM, meaning that there was practically no additional cost over FPM. In fact, in its heyday, EDO cost less than FPM and yet offered higher performance.

EDO RAM was ideal for systems with bus speeds of up to 66MHz, which fit perfectly with the PC market up through 1997. However, since 1998 with the advent of faster system bus speeds (100MHz and above), the market for EDO has rapidly declined as the newer and faster SDRAM architecture has become the standard for new PC system memory.

A variation of EDO is burst EDO (BEDO). BEDO is basically EDO memory with special burst features for even speedier data transfers than standard EDO. Unfortunately, the technology was owned by Micron and not a free industry standard, so only one chipset (Intel 440FX Natoma) ever supported it. BEDO was therefore quickly overshadowed by industry-standard SDRAM, which was favored among PC system chipset and system designers over proprietary designs. As such, BEDO never really saw the light of production, and to my knowledge no systems ever really used it.

Leave a comment or ask a question
Total comments: 0

Memory Processor Motherboards and buses Disclaimer

  • The e-articles directory is not responsible for any and all copyright infringements by writers and authors. If you suspect the information contained by this page for any copyright infringements, please contact us to investigate the issue
The evolution of Microprocessors from 1971 to the Present - It is interesting to note that the microprocessor had existed for only 10 years prior to the creation of the PC! Intel invented the microprocessor in 1971; the PC was created by IBM in 1981. Now mo (more...)
How SIMM DIMM and RIMM memory work - Originally, systems had memory installed via individual chips. They are often referred to as dual inline package (DIP) chips because of their designs. The original IBM XT and AT had 36 sockets on t (more...)
Troubleshooting Memory - Memory problems can be difficult to troubleshoot. For one thing, computer memory is still mysterious to people because it is a kind of "virtual" thing that can be hard to grasp. The other difficult (more...)
Guidelines when upgrading memory on older systems - When upgrading an older motherboard, it is sometimes impossible to match the installed memory. Some motherboards have 30-pin and 72-pin SIMM sockets, and many have both SIMM and DIMM sockets. I (more...)
Guidelines when upgrading memory in Pentium II/III/IV Celeron and Athlon systems - These systems are excellent candidates for memory upgrades. Early Pentium II systems often have only 16 MB of RAM. In the price-sensitive consumer Celeron market, many early systems shipped wit (more...)
Power6 Processor: World`s Fastest Processor - Increases the processing speed to 4.7 GHz A revolutionary device in the form of tiny chip has been designed by IBM which has put the world in wonders. Power6 is really a mind-blow (more...)
About Clocking - In computers, a serial signal is one in which the bits of data of the digital code are arranged in a series. They travel through their medium or connection one after another as a train of pulses (more...)
Hardware Flow Control in the Serial Interface - Several of the signals in the serial interface are specifically designed to help handle flow control. Rather than a simple on and off operation, however, they work together in an elaborate ritua (more...)
Software Flow Control in the Serial Interface - The alternate means of handshaking, software flow control, requires your serial peripheral and PC to exchange characters or tokens to indicate whether they should transfer data. The serial perip (more...)
IrDA overview - The one thing you don't want with a portable PC is a cable to tether you down, yet most of the time you must plug into one thing or another. Even a simple and routine chore like downloading file (more...)

 
free content
    Copyright © 2006 - 2012 e-articles.info.
The texts, articles and tutorials in the directory are property of their respective owners and authors.